Tuesday, October 18, 2011

Gmc Trucks 2001

##title##
The first mass-produced GM inline 6 was introduced in 1929 on Chevrolet cars and trucks, replacing the company's first inline-4. Richard Grant (Chevrolet marketing executive) insisted that the new design boast overhead valves. Chevrolet had long been known for its "valve-in-head" four-cylinder engines. William S. Knudsen's cast-iron wonder was produced through 1936.



Slammed 2001 GMC Sierra Truck


Scream\x26#39; 2001 GMC Sierra Photo

It was 194 cubic inches (3.2 L) in size and produced 50 hp (37 kW). This engine used a forged steel crankshaft with three bearings and cast iron pistons. Bore and stroke was 3.3125 in (84.14 mm) by 3.75 in (95.25 mm). The 194 was shared with Chevrolet and GMC trucks for 1935 and 1936.



Custom Mini Trucks 2001 Gmc


A balanced crankshaft was introduced for 1932, while a higher (5.2:1) compression ratio upped output to 60 hp (45 kW). In 1934, a new cylinder head pushed output to 80 hp (60 kW).



2001 GMC SONOMA 2-DR TRUCK FOR


This name stovebolts came into common use as the 1/4″ × 20 slotted-head bolts are used at numerous points on the engine (and body) of these cars. The slotted-head bolts are commonly used in the assembly of unwelded wood-burning stoves.



2001 GMC Trucks



2001 Gmc Z71 Drivers Side View


In 1935 and 1936, GMC and Chevrolet used an Oldsmobile 213 L-head engine. For 1937 and 1938, they used Oldsmobile's 230 L-head engine.



2001 Gmc Sierra 2500 Hd Slt


2001 GMC SIERRA-$4000 - Trucks


2001 GMC SONOMA 2-DR TRUCK FOR

The next-generation Chevrolet inline 6 was introduced in 1937 and phased out in 1963 in the US, and 1979 in Brazil.



2001 Gmc Sierra Z71



Insight to GMC Sierra 2001


This engine had a 216-cubic-inch (3.5 L) displacement with a 3.500" (88.90mm) bore and a 3.750" (95.25 mm) stroke. A four-bearing crankshaft was added, along with 6.5:1 compression pistons, for 85 hp (63 kW). A new cylinder head in 1941 bumped output to 90 hp (67 kW), and 6.6:1 compression gave the 1949 model 92 hp (69 kW). This generation did not use a fully pressurized oiling system. The connecting rods were oiled using an "oil trough" built into the oil pan that had spray nozzles that squirted a stream of oil that the connecting rods (which were equipped with dippers) caught on the fly and supplied the necessary oil for the rod bearings.



2001 gmc truck



2001 GMC SONOMA 2-DR TRUCK FOR


2001 Gmc Sierra 2500Hd Engine


trucks v8 popular thier


2001 GMC T6500

No comments:

Post a Comment